Skip to main content

Taylor Mill Historic Site

Contact

242 Island Pond Road, Derry, NH 03038

Hours and Fees

Closed for the season.

Off-season use: The off-season poses unique risks inherent when participating in outdoor recreational activities. Please be aware that many State Parks areas and trails are not staffed during the off season, and day-use fees are not collected. Recreationists should possess the necessary knowledge, skill, and equipment to enusre their own safety. Users assume all risk while recreating in State Park lands.

Mill Staff
A.J. Dupere – Urban Forester
Robert Spoerl – Caretaker

or more information: Contact the A.J Dupere, Urban Forestry Center at 45 Elwyn Road, Portsmouth, N.H. 03801-5701, telephone (603) 431-6774.

Activities and amenities

Fishing Canoeing Pet-friendly Picnic Area Historical Site

About the Park

The 200-year old "Taylor Up and Down Sawmill" is the property of the State of New Hampshire and is cooperatively maintained and run by the Division of Parks and Recreation and the Division of Forests and Lands Planning and Community Forestry Bureau.

The Taylor Sawmill is situated on the 71-acre Ballard State Forest in Derry, New Hampshire. Robert Taylor, for whom the mill is named, bought the property in 1799 and began operating an "up and down" sawmill similar to the current one about 1805. We are not sure of exactly when this mill stopped running.

The original mill, for the most part, had been sold for scrap when Ernest R. Ballard purchased the land in 1939. Mr. Ballard searched extensively over much of New England for another "up and down" sawmill and finally found one in Sandown, New Hampshire owned by Dan Hoit. The mill had been disassembled fifty years earlier and was stored under a barn. Mr. Ballard paid $180 for it. He and his wife spent two years assembling it and finding the necessary parts to put it in operating condition.

Unable to get an original water wheel and learning of the astronomical expense of getting another built by hand, Mr. Ballard purchased a water wheel from a firm in Hanover, Pennsylvania, the Fitz Water Company, for $3,000. The wheel was 6 feet wide, 12 feet in diameter, weighed about 1,000 pounds, and had 40 buckets.

The capacity of this sawmill is limited to logs 12 feet in length and 32 inches in diameter. The mill operates at about 60 strokes per minute. The log carriage feeds the saw at about 3/8 inch per stroke. Records indicate that other up and down sawmills were capable of sawing logs up to 38 feet in length with a diameter substantially larger than the capacity of the Taylor Mill.

This entire property, including the sawmill, the house nearby, and 71 acres of land, were very generously donated to the State of New Hampshire in 1953 by Mr. Ballard.

New Hampshire Chronicle came for a visit. If you missed it, watch it here.

Additional Information

Taylor Sawmill - A Technical Exploration
Alexander Knight House Project
Timber Framers Guild
The Chester Bridge - NH Covered Bridge Project
Ballard State Forest Model
 

Access for Persons with Disabilities

Visit our Park Accessibilty page for more information on specific accessibilty needs or questions, please contact the individual park office directly.

Drone use is restricted at all NH State Parks. Drone operators are not permitted to take off or land within NH State Park boundaries.
Seal of the State of New Hampshire © NH Department of Natural and Cultural Resources
172 Pembroke Road Concord, NH 03301